We tell you where the savings are: which tools pay to regrind, what your worn carbide is worth, and where a second source or a different tool type cuts the carbide bill. Written reply within 3 working days. The short verdict is free; the full written report on the same list is EUR 190 (~US$209), charged in EUR; final USD conversion and tax may vary.
Uncoated carbide rod that cost about 30 EUR per kg in October 2025 was quoted at 200 to 240 EUR per kg in May 2026 (E. Zoller GmbH & Co. KG, reported by MM Zerspanung on 13 October 2026).
Brand-neutral: no manufacturer pays for placement here. Equivalents come from indexed catalogue data, not sponsorship.
One insert per line. Grade is the only required field, the rest sharpen the audit. New to this? See a fully worked example audit first →
A shared ISO application position creates a candidate shortlist, not a verified equivalent. Any savings scenario depends on your prices and measured tool life; no saving is guaranteed. Check the candidate against manufacturer charts and test it on a sample part before switching.
The audit gives you a candidate shortlist, not a savings guarantee. Measure tool life and cost per part on one machine before deciding. The free grade check shows which lines have documented candidates; a report (EUR 9 for one grade, EUR 22 for two or three) adds an evidence summary, any available manufacturer speed data and a cost-per-part worksheet for that trial.
Match the grade to its ISO application position (for example P25 for general steel turning) and look for grades at the same position from other manufacturers. Grades sharing an ISO application position are only potential candidates, not proven drop-in counterparts. The Cost Audit helps form a brand-neutral shortlist; check manufacturer evidence, quoted prices, and a shop trial before switching.
A shared ISO position is a screening clue, not proof of interchangeability. Substrate, coating, geometry and tool life may differ. Check the manufacturer charts and validate on a sample part before switching production.
Possible savings depend on actual quoted prices, tool life, cycle time and trial results. We cannot know your supplier prices. Compare measured cost per part before claiming a saving.
Free, no strings: 8-brand grade cross-reference (PDF) · ISO material-group cheat-sheet (PDF)
Prefer ChatGPT? Use our free grade cross-reference GPT →