CUTTINGTOOLS / AI
Find equivalents

Cross-brand grade equivalence · brand-neutral

MOLDINO GM8035: candidate alternatives

How to read this page. These alternatives are compiled from grade comparison charts the manufacturers publish themselves. A direct peer is a grade listed in the same row of a manufacturer comparison chart as GM8035: that is chart comparability, not verified cutting performance and not a drop-in swap. Grades that share only the ISO 513 application position are listed apart, marked not verified. Substrate, cobalt content, coating and edge preparation still differ, and so will tool life and the cutting data you should start from. Validate any swap on a sample part before you change production. Something wrong on this page, or a grade you want removed? research@cuttingtoolsai.eu.

MOLDINO GM8035 sits at ISO 513 application classes M30, P30, P40 — stainless steel, steel. No manufacturer chart on file lists a direct peer for it. 129 grades from other makers share an ISO position with it. None has been verified.

Alternatives by evidence

Direct peers

Listed in the same row of a manufacturer comparison chart. This is chart comparability, not verified cutting performance.

No manufacturer chart on file lists a direct peer for this grade. Grades at the same ISO position are listed as not verified.

Same ISO position, not verified

These grades overlap in ISO position only. No manufacturer chart lists them together, and operation and tool material are not verified.

  • ISCAR IC830 ISO M30 P30 P40 · not verified
  • Kennametal KC735M ISO M30 P30 P40 · not verified
  • TaeguTec TT8020 ISO M30 P30 P40 · not verified
  • Kennametal KC725M ISO M30 P40 · not verified
  • Kyocera PR1535 ISO M30 P30 · not verified · carbide

104 more not shown.

More wear-resistant alternatives

Positioned below this grade on the ISO scale (more wear resistance, less toughness). ISO position only, not verified.

  • Kennametal KCPK30 ISO P30 · not verified
  • Mitsubishi VP45N ISO P30 · not verified
  • Sandvik GC1125 ISO P30 · not verified
  • Sumitomo T2500A ISO P30 · not verified
  • Sumitomo T2500Z ISO P30 · not verified · cermet

15 more not shown.

The free check and the report show each grade with its sources: check GM8035 free.

What this does and does not tell you

An ISO 513 application class says which material group and which range of operations a grade is built for. Two grades sharing a class are built for the same job. They are not identical: substrate grain, cobalt content, coating and edge preparation still differ, and so will tool life and the cutting data you should start from. Treat a candidate here as the shortlist for your own trial, not as a drop-in replacement.

Everything above is derived from the makers' own published application data. Nothing is inferred from price, availability or popularity, and no manufacturer pays to appear here.

Related candidate alternatives

All cross-brand grade candidates

Source-backed grade report · PDF + XLSX

Check MOLDINO GM8035 against the published chart evidence first. If this grade has a documented candidate, you can order an automatically generated report for one grade (about US$10, charged EUR 9), or add up to two grades (about US$24, charged EUR 22). Currency conversion and tax at checkout may change the USD amount. A chart comparison is not a guaranteed substitute.

Check this grade and see the report →
Cost check · free · brand-neutral

Are you overpaying on your MOLDINO GM8035 inserts? Paste your insert list and get a cost audit in about 30 seconds: cross-brand candidate alternatives at the same ISO application position, and where you are likely overpaying. No signup, no sales call.

Run a free cost audit → Check your whole grade list · free

After the free check: a sourced PDF + XLSX report from EUR 9 for one grade. How buying works

Ask about your own case

Material, operation, machine — get a grade and a starting cutting data set, grounded in the same reference data.