CUTTINGTOOLS / AI
Find equivalents
Form tolerance · ISO 1101

Flatness

Limits the gap between the highest and lowest points of a surface, with no datum involved.

In the shop

Symptom: a face measures high in the middle or at the edges, or rocks on a surface plate. Likely cause: clamping distortion and residual stress, which are often a bigger factor than the tool. First check: release the clamps and measure again, and see whether the error follows the clamping force. If it does, rough first, relieve the clamping, then finish; on a part that keeps moving, finish one face, flip it and take light passes on each face in turn. The right finishing depth depends on part geometry, material and rigidity, but keep it above the cutting edge hone radius (the rounding of the cutting edge itself, not the insert nose radius) so the pass cuts instead of rubbing.

General shop guidance in our own words. The drawing and the standard it cites decide; verify on a sample part.

Related form tolerances

Circularity · Cylindricity · Straightness

Ask about your drawing

Tell the advisor the feature, the tolerance on the drawing and the material. It answers with machining choices, brand-neutral.

Sources

Definition written in our own words and checked against keyence.com. Symbol and term names follow ISO 1101; we do not reproduce standard text. See the full index.

Shop note reviewed by our tooling specialist (carbide cutting-tool production and tool measurement background) on 12 October 2026.